Differences between version 2 and predecessor to the previous major change of TrekIIStringBasswithSimultaneousRetentionofHammondPedalTones.

Other diffs: Previous Revision, Previous Author

Newer page: version 2 Last edited on March 16, 2014 2:12 pm. by
Older page: version 1 Last edited on March 16, 2014 12:16 pm. by
@@ -26,8 +26,8 @@
 The Pluck/Sustain control is usually mounted to the bottom of the organ front wooden rail. Wires from the Pluck/Sustain control plug into the circuit board via a Molex connector. 
  
 The power transformer is mounted near the run motor end of the organ to prevent the induction of any hum/noise into the organ signal path. 
  
-For photos of the pedal contacts, wiring and Trek II circuit board, go to the organ forum at: http:\\????
+For photos of the pedal contacts, wiring and Trek II circuit board, go to the organ forum at: http://www.organforum.com/forums/showthread.php ?30718-String-Bass-(Trek-II)-with-Simultaneous-Retention-of-Hammond-Pedal-Tones  
  
  
 !—JohnMihevic 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.