Differences between current version and previous revision of PercussionVolumeDropM3.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 14 Last edited on December 23, 2011 2:33 am. by 71.238.236.118
Older page: version 13 Last edited on December 23, 2011 2:25 am. by 71.238.236.118
@@ -29,9 +29,9 @@
 [http://www.dairiki.org/hammond/pics/wilford/M3rescliped.jpg] 
  
 R2 Has been clipped off leaving some lead to solder too. 
  
-*This resistor doesn't need to be clipped out. It would disappear to the circuit when jumped, and the mod could be easily reversed. I'm using ground bus wire since it's going to ground anyway, and it's easier to work with than insulated wire. Thanks for the great mod and pics. -towlie 
+*This resistor doesn't need to be clipped out. It would disappear to the circuit when jumped, and the mod could more easily be reversed. It might also be easier for someone else to find using the schematic . I'm using ground bus wire since it's going to ground anyway, and it's easier to work with than insulated wire. Thanks for the great mod and pics. -towlie 
  
  
 [http://www.dairiki.org/hammond/pics/wilford/M3jumper.jpg] 
  

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.