HammondWiki - Diff: OilingTheHammond

Differences between current version and previous revision of OilingTheHammond.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 2 Last edited on February 15, 2003 9:04 am. by JeffDairiki
Older page: version 1 Last edited on February 12, 2003 3:54 pm. by
@@ -5,5 +5,7 @@
 There have been problems reported about over oiled [Scanner]s though, and a scanner cleaning and ScannerRebuild can be quite expensive. According to JerryWelch at the OrganServiceCo, people over oil the scanner by filling its oil cup all the way up when actually only the wick in the cup should be saturated. The scanner oil cup is located between the run motor and the scanner at the far left end of the tone generator. 
 The main generator is best oiled by putting a couple of teaspoons of oil directly into the two funnels located on top of the generator. 
- [HammondMaintainanceAndTroubleshooting]  

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.