HammondWiki - Diff: ManualTapering

Differences between version 4 and previous revision of ManualTapering.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 4 Last edited on December 14, 2012 2:15 am. by
Older page: version 3 Last edited on March 21, 2005 7:51 am. by
@@ -3,12 +3,11 @@
 In contrast, the Hammond spinets (at least the M- series) all have constant resistance resistance wires. In the M-Series, all resistances are 16 ohms. (Sometimes the wires of of differing lengths, but their gauge is varied as well so that the total resistance is the same.) 
  
 PleaseAddToThisSection 
  
-Carsten Meyer has drawn up this chart showing the tapering on a console.  
- (I'm not quite sure _which_ console this is for --- the tapering varied between the various models, I think .)  
+Carsten Meyer has drawn up this chart showing the tapering on a B3 console compared to a spinet (M- or T-series). Remark by Carsten: I think tapering was not only made for "click reduction" and smooth sound, but also took care of differences in generator impedance (inner resistance). Therefore the "jump" in tapering wire resistance at notes with filter circuit . 
  
 [http://www.keyboardpartner.de/hammond/diagrams/KeyboardTapering.png] 
  
 Also MikeFulk has provided a scan of this tapering diagram. 
  
 [http://www.dairiki.org/hammond/pics/taper.gif] 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.