Note: You are viewing an old revision of this page. View the current version.

Support HammondWiki. Donate!
PayPal

The following write-up was posted by MikeCasino to TheHammondForum:

The Leslie710 is a 90 watt 2 channel solid state bi-amp system. It is intended for use, of course, with two channel organs --- not too exciting yet since most of us are using single channel organs.

Well, lets take a look at what the Leslie 710 and a popular single channel solid state Leslie have in common. I'm going to use a comparison with the Leslie model 760 / 770. The 4 ohm bass speaker, 16 ohm treble driver and horn assembly are the same. The upper and lower fast / slow motors are the same. The 40 watt treble amp and the 50 watt bass amp are also the same. The power supply units are basically the same. They both have a motor control with an electronic brake that engages the slow motor when you go from tremolo to stop mode for 7 to 13 seconds. They both use a 9 pin input plug.

The cabinet for the Leslie 710 is a full height wooden cabinet like the 147, 122, 21H, 770, 251, etc. The only difference is the look of the cabinet louvers and the mounting of the lower motor assembly.

What is missing from the Leslie 710? I'm glad you asked! An electronic crossover, a bass rotor, the spindle and belt are all different sizes. That's all.

See Leslie710Modifications for a discussion of how to remedy these deficiencies.

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.