Differences between version 4 and previous revision of HowToCleanDrawbarContacts.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 4 Last edited on February 15, 2003 8:56 am. by
Older page: version 3 Last edited on February 15, 2003 8:40 am. by
@@ -15,5 +15,5 @@
  
 ;:We remove the drawbar contact and burnish it with a contact burnishing tool. Be sure the nichrome resistance wire (1 ohm) is not broken. If it (they) are, do not try to solder them. Go forth and buy 1/8 watt 1 ohm resistors and solder them where the wire was. They fit just duckey and work great. 
  
 ------- 
-TopicTroubleshooting  
+TopicRepair  

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.