HammondWiki - Diff: HowToCleanDrawbarContacts

Differences between version 5 and previous revision of HowToCleanDrawbarContacts.

Other diffs: Previous Major Revision, Previous Author

Newer page: version 5 Last edited on April 9, 2003 7:14 pm. by
Older page: version 4 Last edited on February 15, 2003 8:56 am. by
@@ -10,10 +10,21 @@
  
 ''''* ''The original quote recommended Cramolin R-5 rather than [DeoxIT]. [Caig] no longer produces Cramolin R-5, due to its Freon content. The replacement product is [DeoxIT] (Cramolin Red replacement), [PreservIT] (Cramolin Blue replacement).'' 
  
 ------- 
-! BobSchleicher says: 
+<strong> BobSchleicher says:</strong>  
+  
+ We remove the drawbar contact and burnish it with a contact burnishing tool.  
+ Be sure the nichrome resistance wire (1 ohm) is not broken.  
+ If it (they) are, do not try to solder them.  
+ Go forth and buy 1/8 watt 1 ohm resistors and solder them where the wire was.  
+ They fit just duckey and work great.  
+  
+JeffDairiki says~:  
+ ''I have quite a few of the one ohm 1/8 watt resistors (they're _really_ cheap in lots  
+ of 200 from Mouser).  
+ If you need a few, let me know --- I'd be happy to mail you some.''  
+ -- [Jeff|mailto:dairiki@dairiki.org]  
  
-;:We remove the drawbar contact and burnish it with a contact burnishing tool. Be sure the nichrome resistance wire (1 ohm) is not broken. If it (they) are, do not try to solder them. Go forth and buy 1/8 watt 1 ohm resistors and solder them where the wire was. They fit just duckey and work great.  
  
 ------- 
 TopicRepair 

The content of this page is Copyright (C) 2000, 2001, 2002 Geoffrey T. Dairiki and the other authors of the content, whoever they may be.
This is free information and you are welcome redistribute it under certain conditions; see http://www.dairiki.org/HammondWiki/opl.html for details.
Absolutely no warrantee is made as to the correctness of the information on this page.